|
The Belt Driven Live Roller Conveyor
provides minimum pressure accumulation with
heavy duty rollers on close centers. The model
BDLR25 provides an excellent transport
conveyor for pallet loads or corrugated
bundles. Adjustment screws in each zone
provides adjustable driving force for the
carrying rollers.
Carrier Roller: 2.500” dia., 11 ga. wall tubes with
11/16 hex cold rolled steel axle spring retained. Standard A51 bearings
are greased packed.
Roll Centers: 3.00”, 4.00”, and 6.00”
Belting: Standard B25 PVC-120 black, friction surface. Belt is
shipped laced and installed on conveyors up to 10’ long. On all other
conveyors the belt is shipped loose with lacing installed for field installation.
Between Frames: Standard widths are 39”, 43”, 51”, 57”,
61”, 65”, 73”, 78”, and 84”. Also available
from 39” to 84” in 1” increments.
Belt Widths: 12” wide on 39 through 48” B.F., 18” wide
on 49” through 84” B.F. conveyors.
Length: 10’ to 80’ in 1” increments.
Standard Sections: 60” long, adjustable with jack screws.
Drive: Standard D46 - end, right hand side, 8” pulley. Drive has cast
iron worm gear speed reducers with standard M03 3/4 H.P. 230/460 volt TEFC
motor.
Speed: Standard 30 feet per minute. Also available from 10 to 120
fpm.
Bearings: Sealed pre-lubricated, cast iron flange ball bearings.
Frame: 11-3/8” x 1-1/2” x 3/16” formed steel channels.
Drive Pulley: 8” dia. with 1-7/16 dia shaft crowned and lagged. Mounted
in 2 bolt flange bearing.
Take-Up Pulley: 4” dia. with 1-3/16” dia. shaft, crowned mounted
in 2 bolt flange bearing.
Snubber Roller: 2.5 dia. 11 ga. wall tubes with 11/16 hex cold
rolled steel axle, spring retained. Standard A55 bearings are grease packed
with front and back seals.
Tension Roller: 1.9 dia. 16 ga. wall tubes with 7/16” hex cold rolled
steel axles, spring retained. Standard A11 bearings are grease packed. The
same for return rollers.
Capacity: 1000 pounds per lineal foot. Maximum 4000 pounds unit
load per section. Total conveyed load not to exceed capacity shown in chart.
Supports: SPHH style located on nominal 5’ centers available for top
of carrier rollers above 12” to 42” at no additional charge.
No support required for minimum elevation 12” top of bed rollers.
Roll Covers: Standard V98: No Roll Cover
Finish: Standard PP94: Safety Blue, Epoxy Powder Coat.
— Live Roller Chain
Conveyors
— Belt Driven Live Roller Conveyors
— Gravity Conveyors
— Belt Conveyors
— Flexible / Extendable Conveyors
Click HERE to
download our Conveyor brochure.  |
Download
Acrobate Reader  |
|
